NDIS Reset In Progress 0x8034000D — Real Fixes

1. The Real Culprit: Buggy or Outdated Network Driver

Nine times out of ten, this error hits because the network driver craps out during a reset. I've seen it on Realtek PCIe GbE, Intel I219-V, and Broadcom NetXtreme adapters—especially after Windows updates or driver rollouts. The driver starts a reset sequence, hangs halfway, and the interface goes dark.

Fix: Roll back the driver or install the OEM version.
Open Device Manager, expand Network adapters, right-click your NIC, select Properties > Driver. Click Roll Back Driver if it's grayed out—that's a sign Windows Update pushed a bad driver. Instead, grab the driver from your motherboard or laptop vendor's support site (not the chipset maker's). Example: for a Dell Latitude, use the Dell driver, not Intel's generic one.

If rollback isn't available, uninstall the device (check Delete the driver software for this device), then reboot. Windows will install a generic driver that usually works fine. Test with ping 8.8.8.8 -t for 30 seconds to confirm stability.

I've also seen this on Hyper-V virtual switches. If you're running VMs, uncheck Allow the computer to turn off this device to save power (see cause #3) and disable SR-IOV in the virtual switch properties—that feature is notoriously flaky with NDIS resets.

2. Physical Layer Problems: Bad Cable or Port

Don't laugh—I've wasted hours chasing driver bugs only to find a crushed Cat6 cable. This error fires when the NIC detects a link flap during a reset cycle. A loose connection, bent pin, or marginal cable can trigger it.

Fix: Swap the cable and test the port.
Try a known-good patch cable. If you're using a surge protector or powerline adapter, bypass it—they introduce noise. Test in a different switch port. For laptops, reseat the dock or USB-C adapter; I've seen this on ThinkPad USB-C docks with Realtek chips.

Run wmic nic get name, speed, adaptertype to check link speed. If it drops below 1 Gbps with a short cable, you've got a hardware problem. Also check the NIC's status light—if it blinks erratically during the error, the cable is your culprit.

3. Windows Power Management Killing the NIC Mid-Reset

Windows loves to put the NIC to sleep when you aren't looking. If the interface is resetting (say, after a network change or IP renewal) and the OS decides to throttle it, you get 0x8034000D. This happens most often on laptops running on battery or after waking from sleep.

Fix: Disable power saving on the NIC.
In Device Manager, right-click your network adapter > Properties > Power Management. Uncheck Allow the computer to turn off this device to save power. Also uncheck Allow this device to wake the computer (it doesn't fix the error, but it stops unexpected wake-ups).

Then go to Control Panel > Power Options > Change plan settings > Change advanced power settings. Expand Wireless Adapter Settings > Power Saving Mode and set to Maximum Performance. For wired adapters, look for PCI Express > Link State Power Management and set to Off.

Reboot after these changes. I've seen this fix stick for months on HP EliteBooks and Dell OptiPlex machines.

Quick-Reference Summary

One last thing: If none of these work, run netsh int ip reset and netsh winsock reset from an admin prompt, then reboot. It's a hail mary, but I've seen it clear weird NDIS states. After that, if the error persists, consider replacing the NIC—those cheap Realtek chips die young.